User's Manual
Table Of Contents
- RAy2 Microwave Link
- Table of Contents
- Important Notice
- Quick guide
- List of documentation
- 1. RAy2 – Microwave Link
- 2. Implementation Notes
- 3. Product
- 4. Accessories
- 5. Step-by-step Guide
- 6. Installation
- 7. Configuration
- 8. Command Line Interface
- 9. Troubleshooting
- 10. Technical parameters
- 11. Safety, environment, licensing
- Appendix A. Antenna dimensions
- Appendix B. Rain zone map
- Appendix C. IP address in the PC (Windows XP)
- Appendix D. IP address in the PC (Windows 7)
- Appendix E. IP address in the PC (Windows 8)
- Appendix F. SSH key generation
- Appendix G. Https certificate
- Appendix H. Unit block diagrams
- Index
- Appendix I. Revision History
The Status menu provides basic information about local and remote station. Informations is valid the
moment the page is open, or the Refresh button is hit.
The Status – Brief tab shows only the most important values whereas the Status – Detailed tab
provides further details. Below is a list of all values according to the tab Status – Detailed.
The icon marks fields which are automatically updated with 30 sec period (or 1 sec when the Start
button is active).
7.3.1. Status - General
LED indicators
Unit status indication
- Radio link OK
- Radio link interrupted
Green
Red
A - AIR
- System OKGreenS - SYS
- ETH1 port - Link 10/100/1000
- ETH2 port - Link 10/100/1000
Green
Orange
E - ETH
Unit type indicator.Unit code
Unit serial number.Serial no.
Station name assigned by user.Station name
Station location assigned by user.Station location
Unit’s firmware version.Firmware version
The internal real-time clock. The clock is set manually or it is synchronized
with NTP server and set for both units.
Date, Time
Temperature inside the unit (on the modem board).Inside temperature [°C]
Unit’s power supply voltage level.Voltage [V]
The power supply input the unit is powered from.
PoE - unit is powered via Ethernet cable plugged into port "ETH1+POE".
AUX - unit is powered via DC cable plugged into port "P".
Power supply
7.3.2. Status - Radio
Radio unit type: L (Lower) or U (Upper) part of the frequency band.Radio type
Horizontal or vertical polarization based on the physical installation. Indic-
ates the polarization of the received signal. Local and Peer are indicated
separately. The proper position of the cable is sideways down.
Notice for RAy2-17 and RAy2-24 links: One side of the link must be installed
in vertical polarization and the other in horizontal polarization.
Polarization
Displays the currently used frequency table in format <name:version>.Frequency table
Current transfer capacity of radio channel for user data.Net bitrate [Mbps]
The maximum RF channel capacity according to installed feature key.Max. net bitrate [Mbps]
One of the standard channel widths can be selected. This parameter must
be set identically in local and remote.
Bandwidth [MHz]
Used channels. Both number of the channel and frequency in GHz are
listed.
TX and RX channel [GHz]
Modulation type currently used for transmitting. When adaptive modulation
is enabled, the ACM letters are displayed as well as information about
TX modulation
RAy2 Microwave Link – © RACOM s.r.o.66
Configuration