User's Manual
Table Of Contents
- RipEX2 Radio modem & Router
- Table of Contents
- Important Notice
- 1. Quick guide
- 2. Product
- 3. Accessories
- 4. Installation
- 5. RipEX2 in detail
- 6. Web interface
- 7. Settings
- 7.1. Interfaces
- 7.1.1. Ethernet
- 7.1.2. Radio
- 7.1.3. COM
- 7.1.4. Terminal servers
- 7.1.5. Cellular
- 7.2. Routing
- 7.2.1. Static
- 7.2.2. OSPF
- 7.2.2.1. Description
- 7.2.2.2. Common - Common settings
- 7.2.2.3. Network - Areas and interfaces - Areas
- 7.2.2.4. Network - Areas and interfaces - Interfaces
- 7.2.2.5. Network - Areas and interfaces - Neighbors
- 7.2.2.6. Network - Areas and interfaces - Networks
- 7.2.2.7. Static rules
- 7.2.2.8. Import filter
- 7.2.2.9. Export filter
- 7.2.3. BGP
- 7.3. Firewall
- 7.4. VPN
- 7.5. Security
- 7.6. Device
- 7.7. Advanced
- 7.1. Interfaces
- 8. Diagnostics
- 9. Technical parameters
- 10. Safety, regulations, warranty
- 10.1. Frequency
- 10.2. Safety distance
- 10.3. High temperature
- 10.4. Battery disposal
- 10.5. Instructions for Safe Operation of Equipment
- 10.6. SW license
- 10.7. EU Compliance
- 10.8. Compliance Federal Communications Commission and Innovation, Science and Economic Development Canada
- 10.9. Compliance ANATEL Brasil
- 10.10. Warranty
- 10.11. RipEX2 Availability and service life time
- 10.12. RipEX2 maintenance
- Appendix A. Abbreviations
- Index
- Revision History
• Destination IP
This is IP address of destination RipEX2, either ETH or Radio interface.
• Transmit as broadcasts
List box {On; Off}, default = "Off"
Allows sending of the packets incomming from COM port as broadcast.
• Accept broadcasts
List box {On; Off}, default = "Off"
On: Broadcast packets from the radio channel will be send to the COM port.
Off: Only unicast packets will be send to the COM port.
7.1.3.3.4. DNP3
Each frame in the DNP3 protocol contains the source and destination addresses in its header, so there
is no difference between Master and Slave in terms of the RipEX2 configuration. The DNP3 allows
both Master-Slave polling as well as spontaneous communication from the remote units.
The common parameters (e.g. address translation) shall be set.
• Broadcast
List box {On; OFF}, default = "On"
73© RACOM s.r.o. – RipEX2 Radio modem & Router
Settings