User's Manual
Table Of Contents
- RipEX2 Radio modem & Router
- Table of Contents
- Important Notice
- 1. Quick guide
- 2. Product
- 3. Accessories
- 4. Installation
- 5. RipEX2 in detail
- 6. Web interface
- 7. Settings
- 7.1. Interfaces
- 7.1.1. Ethernet
- 7.1.2. Radio
- 7.1.3. COM
- 7.1.4. Terminal servers
- 7.1.5. Cellular
- 7.2. Routing
- 7.2.1. Static
- 7.2.2. OSPF
- 7.2.2.1. Description
- 7.2.2.2. Common - Common settings
- 7.2.2.3. Network - Areas and interfaces - Areas
- 7.2.2.4. Network - Areas and interfaces - Interfaces
- 7.2.2.5. Network - Areas and interfaces - Neighbors
- 7.2.2.6. Network - Areas and interfaces - Networks
- 7.2.2.7. Static rules
- 7.2.2.8. Import filter
- 7.2.2.9. Export filter
- 7.2.3. BGP
- 7.3. Firewall
- 7.4. VPN
- 7.5. Security
- 7.6. Device
- 7.7. Advanced
- 7.1. Interfaces
- 8. Diagnostics
- 9. Technical parameters
- 10. Safety, regulations, warranty
- 10.1. Frequency
- 10.2. Safety distance
- 10.3. High temperature
- 10.4. Battery disposal
- 10.5. Instructions for Safe Operation of Equipment
- 10.6. SW license
- 10.7. EU Compliance
- 10.8. Compliance Federal Communications Commission and Innovation, Science and Economic Development Canada
- 10.9. Compliance ANATEL Brasil
- 10.10. Warranty
- 10.11. RipEX2 Availability and service life time
- 10.12. RipEX2 maintenance
- Appendix A. Abbreviations
- Index
- Revision History
• Masquerade
List box {On; Off}, default = "On"
Enables / disables SNAT (MASQUERADE) for the packets outgoing to the WWAN interface.
When on, the source address of packets outgoing via the cellular WWAN interface will be changed
to the address assigned to this interface. Returning packets will be correctly routed to this interface.
• Management enabled
Enables / disables access into the unit’s management via the cellular WWAN interface.
SIM1 and SIM2 tabs contain the same setting for SIM1 and SIM2 respectively.
• PIN protection
List box {On; Off}, default = "Off"
Enables / disables the SIM module PIN protection. It has to be switched on if the PIN is required.
The parameter is ignored if the SIM does not require a PIN.
• PIN code
String {0000 – 9999}, default = 0000
The PIN is used only when PIN protection is On and the module requires the PIN.
• Network selection
List box {Automatic; Prefer manual; Lock to manual; Lock to home}, default = "Automatic"
Defines the network selection preferences:
○ Automatic– network is selected automatically.
○ Prefer manual – the network according to the Location area identity (LAI) is preferred. Other
network will be selected when the preferred network is not available.
○ Lock to manual– the network according to the LAI can only be used.
○ Lock to home – only the home network can be used (if the SIM supports PLMN reading).
85© RACOM s.r.o. – RipEX2 Radio modem & Router
Settings