- RAD Data Tiny Bridge Installation And Operation Manual

ManualsBrandsRAD Data comm ManualsNetwork Router100

www.rad.com

International Headquarters

24 Raoul Wallenberg Street

Tel Aviv 69719, Israel

Tel: (972) 3-6458181

Fax: (972) 3-6498250, 6474436

Email: market@rad.com

U.S. Headquarters

900 Corporate Drive

Mahwah, NJ 07430

Tel: (201) 529-1100

Toll free: 1-800-444-7234

Fax: (201) 529-5777

Email: market@radusa.com

Tin

Brid

e-100

iniature Remote Fast

Ethernet Bridge

Specifications are subject to change without prior notice.

386-100-02/05

Installation and Operat

on Manual

ORDERING

TINYBRIDGE-100/#/$

Miniature remote Fast Ethernet bridge

TINYBRIDGE-100/4W/$

Miniature remote Fast Ethernet bridge with 4-wire

WAN interface

# Specify WAN interface:

V24 for V.24/RS-232

V35F for V.35 (female adapter cable supplied)

V35M for V.35 (male adapter cable supplied)

V36 for V.36 (adapter cable supplied)

530 for RS-530

X21F for X.21 (female adapter cable supplied)

X21M for X.21 (male adapter cable supplied)

$ Specify AC for 100–240 VAC switching power

supply with integral AC connector

(may be ordered separately as P/S-AC/5/1200)

Summary of content (9 pages)

PAGE 1
Installation and Operation Manual ORDERING TINYBRIDGE-100/#/$ Miniature remote Fast Ethernet bridge TINYBRIDGE-100/4W/$ Miniature remote Fast Ethernet bridge with 4-wire WAN interface # Specify WAN interface: V24 for V.24/RS-232 V35F for V.35 (female adapter cable supplied) V35M for V.35 (male adapter cable supplied) V36 for V.36 (adapter cable supplied) 530 for RS-530 X21F for X.21 (female adapter cable supplied) X21M for X.
PAGE 2
FEATURES • High performance miniature remote bridge for Fast Ethernet extension • Wire-speed WAN throughput: 19,700 pps at 10 Mbps • 10/100BaseT interface • Synchronous WAN interfaces: V.24, V.35, V.36, RS-530, X.21, or 4-wire modem • Two priority queues according to 802.1p or IP ToS bits • Fault propagation of WAN error conditions to LAN port • Automatic MDIX support • Compatible with applicable parts of IEEE 802.
PAGE 3
FLAG DATA CRC FLAG APPLICATIONS 1 60–1532 2 1 Figure 1. TinyBridge-100 Frame Structure • TinyBridge-100 WAN interface operates in DTE mode. This means it accepts receive and transmit clocks. The timing diagram is shown in Figure 2. Rx Data Rx Clock tSETUP tHOLD 5ns 5ns Figure 3. Bridging and Extending Ethernet over Baseband Modems Tx Data Tx Clock tDELAY 9ns Figure 2. Receive and Transmit Clock Timing Diagrams Figure 4.
PAGE 4
SPECIFICATIONS ETHERNET • Frame size (max) 1536 bytes • LAN Table 2048 MAC addresses with 5-minute automatic aging Figure 5. Extending Ethernet over 4-Wires in the Campus Enviroment • Buffer Up to 120 frames for 64-byte frames • Latency With LAN rate 100 Mbps, WAN rate 10 Mbps: 66 μs for 64-byte frames 1400 μs for 1536-byte frames • Compliance Conforms to IEEE 802.3 • Data Rate 10 Mbps, 100 Mbps • Connectors Shielded RJ-45 • Cable Figure 6.
PAGE 5
WAN • Protocol HDLC • Data Rate Up to 10 Mbps synchronous • Throughput With WAN rate 10 Mbps: 19700 pps for 64-byte frames and increment byte data (00, 01, 02, …) 802 pps for 1536-byte frames and increment byte data (00, 01, 02, …) • 4-wire Range 700m (2300 ft) • Connectors V.24/RS-232, DB-25 female V.35, 34-pin female via adapter cable V.36/RS-422, DB-37 female via adapter cable RS-530, DB-25 female X.21, DB-15 female via adapter cable 4-wire: 5-pin terminal block • Operating Range Using Cat.
PAGE 6
CAUTION European Users To reduce the risk of electric shock, fire and injury to persons: Use only with a power supply which complies with EN 60950. Sicherheitshinweise Das Ausrufezeichen innerhalb des gleichschenkligen Dreiecks soll den Benutzer auf wichtige Bedienungs- und Wartungshinweise in der dem Gerät beiliegenden Dokumentation aufmerksam machen. DECLARATION OF CONFORMITY Mfr. Name: RAD Data Communications Ltd. Mfr.
PAGE 7
Connecting the LAN Interface • Connect the user LAN to the RJ-45 connector of TinyBridge-100. Automatic MDIX allows using straight or crossed cables for the LAN connection. INSTALLATION Configuring TinyBridge-100 1. Identify switches on top panel of TinyBridge-100. 2. Set switches according to Table 1. Table 1.
PAGE 8
ON LNG FLC FP 100 ON yB Tin ri -10 dge 0 TERMINAL BLOCK R PW N WA LAN 100X FD AN FIL OPERATION TX 4-WIRE CABLE TinyBridge-100 operation is automatic. Table 2 shows how to diagnose the status of the TinyBridge-100 from the LED indicators. Table 2. LED Indicators GND RX LED SCREW TERMINAL Figure 7. Connecting the 4-wire WAN Interface WAN Yellow ON – Activity on WAN (includes idle) OFF – No activity on WAN Red1 ON – Error condition on WAN OFF – No error condition on WAN LAN 2.
PAGE 9
Table 5. DB-25 Pin Allocation (V.11) (used for RS-530, X.21, V.36) Table 4. DB-25 Pin Allocation (V.