Specifications

AMC-101 Installing AMC-101 1
Quick Start Guide
Installation of AMC-101 should be carried out only by an experienced technician.
If you are familiar with AMC-101, use this quick start guide to set it up for
operation.
Perform the installation procedures for both the local and the remote units.
1. Installing AMC-101
Instructions given below detail the settings that you have to make in order to
configure AMC-101 for proper operation. The table, which comes after the
configuration instructions, lists the AMC-101 internal jumpers and their possible
settings.
Configuring AMC-101

To configure AMC-101:
1. Disconnect all the cables connected to AMC-101.
1. Unscrew the two rear panel screws holding the top panel.
2. Slide out the top panel to gain access to the interior of the unit.
3. Set the JP2 and JP7 jumpers (see table below).
4. Reinstall the top cover.
Jumper Description Settings (Default settings in bold)
JP2 If illegal combination of card types and selected data
rate is detected, CONFIG alarm is relayed and FLT LED
blinks
If illegal combination of card types and selected data
rate is detected, CONFIG alarm is masked and FLT LED
remains OFF
Jumper installed
Jumper not installed
JP7 If no signal is received from the other side, idle signal is
transmitted
If no signal is received from the other side, idle signal is
not transmitted
Jumper installed
Jumper not installed