- RAD Data Communications Modem User's Manual

ASMi-450 Control from the Control Port

4-22 ASMi-450 Installation and Operation Manual

F--------------------------------------------------------------------------------------------------

Pur

ose

Define the codes used to be sent to the control terminal to perform the following

terminal control functions:

• Clear screen

• Move cursor to screen home position.

• Move cursor to the right by one position.

This command lets you enter manually the desired codes. However, if you are using a

terminal of the following type: VT-52, VT-100, TV-920, FREEDOM-110,

FREEDOM-220, or a terminal which is compatible with one of the terminals listed

above, you can use the DEF TERM command (see DEF TERM command) to select

automatically the corresponding control sequences.

Format

Use

1. To display the current codes, type:

F<CR>

2. The terminal function entry screen is displayed. The screen includes three separate

lines, displayed one after the other. A typical screen, showing all the three lines, is

shown below:

CLEAR SCREEN =hhhhhhhh (clear screen code)

CURSOR HOME =hhhhhhhh (cursor home code)

CURSOR RIGHT =hhhhhhhh (cursor right code)

where h indicates hexadecimal digits.

3. To change a code, bring the cursor under the first digit of the code to be changed, by

pressing <CR>, then enter the appropriate hexadecimal digit.

4. Repeat the procedure until all the necessary digits are changed.

HELP -------------------------------------------------------------------------------------------

Pur

ose

Display an index of the control port commands and the options available for each

command.

Format

& Use

H<CR>

You will see the first HELP page. Press any key to see the next page.