Specifications

Installation and Operation Manual Appendix B Parameter List
ASMi-52CQ Ver. 2.12 Configure Transmission Parameters B-3
B.2 Configure Transmission Parameters
The Modem Setup menu allows you to configure transmission parameters of
ASMi-52CQ, including line and DTE values.
³ To configure the transmission parameters:
1. From the Main menu, select Modem Parameters.
2. Select the ASMi-52CQ slot.
The Modem Setup menu appears (see
Figure B-2 ). The Modem Setup
menu enables you to set the transmission parameters of the local and
remote modems.
3. Configure the transmission parameters. Refer to
Figure B-2 and Table B-2 .
Rows in bold in
Figure B-2 indicate parameters applicable to ASMi-52CQ.
Non-bold parameters listed on a screen apply to other modems installed in
the LRS-24 chassis.
4. Configure the E1/T1 parameters by moving the cursor to NEXT PARMETERS
(E1/T1) field by pressing <Tab>, select YES by pressing <F> or <B>, and
pressing <Tab> again.
The Modem Setup Menu: E1/T1 Parameters screen appears (see
Figure B-3 . Table B-3 explains the E1 parameters, and Table B-4 explains
the T1 parameters on this screen.
5. Configure the SHDSL line parameters by moving the cursor to NEXT
PARMETERS (LINE) field by pressing <Tab>, select YES by pressing <F> or <B>,
and pressing <Tab> again.
The Modem Setup Menu: Line Parameters screen appears (see
Figure B-4 ). Table B-3 explains the parameters on this screen.