Specifications

Configuring ASMi-52L 1
Quick Start Guide
Installation of ASMi-52L should be carried out only by an experienced technician.
If you are familiar with ASMi-52L, use this guide to prepare the units for operation.
1. Installing ASMi-52L
Connecting the Interfaces
1. Connect the line to the rear panel terminal block connector dedicated SHDSL.
2. Connect the DTE to the appropriate rear panel connector.
3. Connect the control terminal to the rear panel CONTROL connector.
Connecting the Power
• Connect the AC or DC power to the ASMi-52L modem.
The unit has no power switch. Operation starts when the power is applied
to the rear panel power connector.
2. Configuring ASMi-52L
Configure ASMi-52L to the desired operation mode via an ASCII terminal
connected to the rear panel CONTROL port directly or via a modem link.
Connecting the Terminal

To connect the terminal:
1. Connect the terminal cable to the CONTROL connector of ASMi-52L.
2. Turn the control terminal on.
3. Configure the terminal to the default communication parameters: 9.6 kbps,
one start bit, eight data bits, no parity, one stop bit.
4. Select the full-duplex mode.
5. Turn the terminal echo off.
6. Disable any type of flow control.
You are now ready to start a control session.