Specifications

Chapter 4 Configuration ASMi-52L Installation and Operation Manual
4-2 Configuring ASMi-52L for Management
The Device Info menu appears (see Figure 4-2).
2. From the Device Info menu, select Sys Contact and enter name of a contact
person; select Sys Location and enter description of the ASMi-52L location;
select Sys Name and enter a name of the unit.
3. Press <Esc> to return to the Management menu (see Figure 4-1).
4. From the Management menu, select Save to save your changes.

To clear system parameters:
1. From the Device Info menu, select Clear sys param.
ASMi-52L displays the following message:
Are you sure !!! Clear (Y/N)
2. Type Y to confirm the deletion.
ASMi-52L deletes all device info parameters.
ASMi-52L
Device Info
Sys description ASMi-52L HW Version: 0.00, SW Version: 1.00E54)
1. Sys contact ()
2. Sys location ()
3. Sys name (ASMi-52L)
4. Clear sys params
>
ESC-prev.menu; !-main menu; &-exit; @-scroll
Figure 4-2. Device Information Menu
Configuring the Host Parameters
ASMi-52L can be managed by a network management station, which is located on
the LAN connected to the 10/100BaseT port. In order to establish a proper
connection, it is necessary to configure the following: host IP address, subnet mask,
default gateway, its trap, read and write communities.

To define the IP parameters:
1. From the Management menu, select Host IP.
The Host IP menu appears (see Figure 4-3).
2. From the Host IP menu, type the following:
 1 to define the host IP address
 2 to define the subnet mask
 3 to set the default gateway IP address
 4 to enter the name of a community with read-only authorization
 5 to enter the name of a community with write authorization
 6 to enter the name of a community to which ASMi-52L will send traps.
3. Press <Enter>.
4. Press <Esc> to return to the Management menu (see Figure 4-1).