Specifications

ASMi-52L Installation and Operation Manual Chapter 4 Configuration
Configuring the Physical Ports 4-19
Filling the Bridge Table
When the 10/100BaseT port operates in the bridge mode, you can assign MAC
addresses to the local or remote LAN.

To fill the bridge table:
1. From the LAN Configuration menu, select Bridge Table.
The Bridge Table appears (see Figure 4-23).
ASMi-52L
Bridge Table
MAC Address Port Type
1. 0010b340500 LAN Static
2. 0040e108070 DSL Static
3. 00000000000 Static
>
ESC-prev.menu; !-main menu; &-exit; ?-help
Figure 4-23. Bridge Static Table, Normal Mode
2. From the Bridge Table, select an empty cell (the one with MAC address
0000000000 and unassigned port) by typing D to move the cursor down or U
to move it up.
You can also select an existing MAC address to reassign it.
3. Once the MAC address is selected, type m to enable editing mode.
The Bridge Table enters editing mode (see Figure 4-24).
4. In the editing mode, select MAC Address and enter a MAC address value.
5. Select Port and assign the current MAC address to the local LAN by entering
LAN or to remote LAN by entering DSL.
6. Select Save All to save the changes.
7. Press <Esc> to exit the editing mode.

To remove MAC address from the table:
1. From the Bridge Table, select MAC address that you intend to remove from the
static table.
2. Enter editing mode, as explained above.
3. Enter all zeros for the MAC address value and save the change.
ASMi-52L
Bridge Table
Type (Static)
1. MAC Address ... (00000000000)
2. Port ... ()
>
ESC-prev.menu; !-main menu; &-exit; ?-help
Figure 4-24. Bridge Table, Editing Mode