Specifications

ASMi-52L Installation and Operation Manual Chapter 4 Configuration
Configuring the Physical Ports 4-21
• In 4-Ethernet port ASMi-52L units, Autonegotiation and Max AutoNeg capability
are located in the Ethernet Configuration sub-menu.
• Autonegotiation and Max AutoNeg capability must be defined for each Ethernet
port.
For 4-port Ethernet ASMi-52L units each port must be defined separately.

To set the Ethernet Port Number
1. Follow the path: Configuration > LAN Configuration > Ethernet Configuration
The Ethernet Configuration menu appears (see Figure 4-26).
2. Set the port number to be defined.
3. Set Autonegotiation and Max Autonegotiation Capability as defined below.
4. Repeat for all the Ethernet ports
ASMi-52L
Lan local configuration>ETH Configuration
1. Port number > (1)
2. Auto negotiation (ENABLE)
3. Max AutoNeg Capability > (100BASE_T-full duplex mode)
4. Save
>
ESC-prev.menu; !-main menu; &-exit; @-scroll 1 user(s)
Figure 4-26. 4-Ethernet Port LAN Ethernet Configuration Menu

To set the autonegotiation:
1. Follow the path depending on your ASMi-52L unit:
 1-Ethernet Port: Configuration > LAN Configuration >Autonegotiation
Toggle between Enable and Disable.
 4- Ethernet Port: Configuration > LAN Configuration > Ethernet
Configuration > Autonegotiation.
2. If the autonegotiation is enabled, select Max AutoNeg Capability.
The Set Capability menu appears.
3. Select the desired LAN operation mode by choosing one of the following:
 10BaseT half duplex
 10BaseT full duplex
 100BaseT half duplex
 100BaseT full duplex.
4. If the autonegotiation is disabled, choose Default Type from the LAN
Configuration menu.
The Set Default menu appears.
5. Select the desired LAN operation mode by choosing one of the following:
 10BaseT half duplex
Notes