Specifications

ASMi-52 Installation and Operation Manual Quick Start Guide
Configuring ASMi-52 3

To configure E1 parameters:
• From the E1 Port Configuration menu (Main menu > Configuration > Port
Configuration > E1 Port Configuration), configure the following E1
parameters:
 Framing mode
 Timeslot assignment.
• You can configure timeslot 0 to be looped or transparent:
 Looped – timeslot 0 is sent back to the E1 interface, when operating
opposite remote units with a serial data interface.
 Transparent – timeslot 0 is transmitted to the remote modem.
• If you operate ASMi-52 with the G732S framing, timeslot 0 is always
transparent and timeslot 16 is always connected.
• When operating a 2-wire ASMi-52 with E1 interface opposite ASMi-52 with
V.35 interface (not in LS mode), assign at least three timeslots, excluding
timeslot 0, to carry data.
• When operating a 4-wire ASMi-52 with E1 interface opposite ASMi-52 with
V.35 interface (not in LS mode), assign at least six timeslots, excluding timeslot
0, to carry data.
Configuring the T1 Interface

To configure T1 parameters:
• From the T1 Port Configuration menu (Main menu > Configuration > Port
Configuration > T1 Port Configuration), configure the following T1 parameters:
 Framing mode
 Line coding
 Receive gain
 Interface type
 Transmit signal mask
 Timeslot assignment.
Configuring the 10/100BaseT Interface

To configure 10/100BaseT parameters:
• From the LAN Configuration menu (Main menu > Configuration > System
Configuration > LAN Configuration), configure the following LAN parameters:
 Operation mode
 Bridge static table
 Aging timeout
 LAN rate.
Note