Specifications

Chapter 4 Managing ASMi-52 via a Terminal ASMi-52 Installation and Operation Manual
4-16 Configuring ASMi-52 System Parameters
ASMi-52
LAN Configuration
Operation Mode (Bridge)
Bridging Mode (Switching)
1. Bridge Table []>
2. Aging Timeout(sec)[10 - 1000000] (10)
3. Auto negotiation (Enable)
4. Max AutoNeg Capability (100BASE_T-full duplex mode)
5. Fault indication (Yes)
6. LAN rate (2304)
7. Save
>
ESC-prev.menu; !-main menu; &-exit; @-scroll
Figure 4-18. LAN Configuration Menu
Filling out the Bridge Table
When the 10/100BaseT port operates in the bridge mode, you can assign MAC
addresses to the local or remote LAN.

To fill out the bridge table:
1. From the LAN Configuration menu, select Bridge Table.
The Bridge Table appears (see Figure 4-19).
ASMi-52
Bridge Table
MAC Address Port Type
1. 0010b340500 LAN Static
2. 0040e108070 DSL Static
3. 00000000000 Static
>
ESC-prev.menu; !-main menu; &-exit; ?-help
Figure 4-19. Bridge Static Table, Normal Mode
2. From the Bridge Table, select an empty cell (the one with MAC address
0000000000 and unassigned port) by typing D to move the cursor down or U
to move it up.
You can also select an existing MAC address to reassign it.
3. Once the MAC address is selected, type m to enable editing mode.
The Bridge Table enters editing mode (see Figure 4-20).
4. In the editing mode, select MAC Address and enter a MAC address value.
5. Select Port and assign the current MAC address to the local LAN by entering
LAN or to remote LAN by entering DSL.