Specifications

ASMi-52 Installation and Operation Manual Chapter 4 Managing ASMi-52 via a Terminal
Configuring ASMi-52 System Parameters 4-19
 10BaseT full duplex
 100BaseT half duplex
 100BaseT full duplex.
6. From the LAN Configuration menu, select Save.
Configuring Fault Indication
If ASMi-52 fault indication is enabled and a fault condition or loss of signal is
detected on the line, the Ethernet link is disconnected by ASMi-52. If fault
indication is not selected, fault conditions are not passed through to the LAN side.

To set the fault indication:
1. From the LAN Configuration menu, select fault indication.
Toggle between Yes and No.
2. Select Save to save your changes
Configuring Control Port Parameters
ASMi-52 embedded software enables you to configure the Control port parameters.

To access the Control port menu:
• From the System Configuration menu, select Control Port.
The Control Port menu appears (see Figure 4-22)
ASMi-52
Control Port
1. Rate >(9600)
2. Interface (DCE)
3. CTS (=RTS)
4. DSR (DTR)
5. Port Control >
6. Save
>
ESC-prev.menu; !-main menu; &-exit; @-scroll
Figure 4-22. Control Port Menu
Changing the Control Port Data Rate
The control port of ASMi-52 supports different data rates that can be configured via
the Rate menu (see Figure 4-23).

To configure the control port data rate:
1. From the Control Port menu, select Rate.
The Rate menu appears (see Figure 4-23).
2. Select the terminal rate by typing the number corresponding to the desired
value, and press <Enter>.