Specifications

Chapter 4 Managing ASMi-52 via a Terminal ASMi-52 Installation and Operation Manual
4-24 Configuring the Physical Ports
 4 to select the dialing mode. TONE, the dial-out modem is instructed to use
DTMF dialing. PULSE, the dial-out modem is instructed to use pulse dialing.
 5 to control the use of an alternate number. The alternate number is dialed
after the specified number of call attempts on the primary number failed.
ENABLE, the use of an alternate number is enabled. DISABLE, ASMi-52
stops the call attempts after the specified number of call attempts on the
primary number failed.
 6 to specify a primary number to dial.
 7 specify an alternate number to dial.
3. Select Save to save the changes.
ASMi-52
Dial out
1. Call Out Mode (None)
2. Number of Retries [0-8] (1)
3. Wait for connect (30 sec)
4. Dial mode (Tone)
5. Alternate number mode (Disable)
6. Primary number ()
7. Alternate number ()
8. Save
>
ESC-prev.menu; !-main menu; &-exit; @-scroll
Figure 4-27. Control Port Dial Out Menu
4.6 Configuring the Physical Ports
The SHDSL and DTE interfaces of the ASMi-52 modem are configured via the
Physical Ports Configuration menu. In addition, this menu allows you to configure
the SHDSL repeaters (if they are installed in line).

To access the Physical Ports Configuration menu:
• From the Configuration menu (Figure 4-8), select Physical Ports Configuration.
The second line of the Physical Port configuration menu changes according to the
DTE interface installed in ASMi-52. The possible options are:
• DTE Configuration for ASMi-52 units with a serial interface (V.35, X.21 or RS-530)
• E1 Configuration for ASMi-52 units with E1 interface
• T1 Configuration for ASMi-52 units with T1 interface
• Blank for ASMi-52 units with 10/100BaseT user interface.
Note