Specifications

ASMi-52 Installation and Operation Manual Chapter 4 Managing ASMi-52 via a Terminal
Configuring the Physical Ports 4-25
Configuring the SHDSL Interface
The ASMi-52 configuration software allows you to change the modem’s
transmission mode (Annex A or Annex B).
Examples given below illustrate the local device configuration procedures.

To change the transmission mode:
1. Display the SHDSL Device Configuration menu (Configuration > Physical Ports
Configuration > SHDSL Configuration menu > SHDSL Device Configuration).
SHDSL Device Configuration menu appears (see Figure 4-28).
2. Select Transmission Mode to choose transmission mode: Annex A or Annex B.
The display is refreshed and a new value appears.
3. Select Save to save the changes.
ASMi-52 units operating in the receive clock mode automatically detect standard
compatibility value of the central units and configure themselves accordingly.
ASMi-52
SHDSL local device configuration
1. Transmission mode : (Annex B)
2. Save
>
ESC-prev.menu; !-main menu; &-exit; @-scroll
Figure 4-28. SHDSL Device Configuration Menu
Configuring the Power Backoff
You can determine if the transmitted power backoff is used.

To configure the use of the power backoff:
1. From the SHDSL Configuration menu, select SHDSL Port Configuration.
SHDSL Port Configuration menu appears.
2. Select Power backoff to enable or disable power backoff.
The display is refreshed and a new value appears.
3. Select Save to save the changes.
Note