Specifications

ASMi-52 Installation and Operation Manual Chapter 4 Managing ASMi-52 via a Terminal
Configuring the Physical Ports 4-35
ASMi-52
Time slot map
1. TS0 TRANS 17. TS16 DATA 33. FULL
2. TS1 MNG 18. TS17 DATA 34. CLEAR
3. TS2 DATA 19. TS18 DATA
4. TS3 DATA 20. TS19 DATA
5. TS4 DATA 21. TS20 DATA
6. TS5 DATA 22. TS21 DATA
7. TS6 DATA 23. TS22 DATA
8. TS7 DATA 24. TS23 DATA
9. TS8 DATA 25. TS24 DATA
10. TS9 DATA 26. TS25 DATA
11. TS10 DATA 27. TS26 DATA
12. TS11 DATA 28. TS27 DATA
13. TS12 DATA 29. TS28 DATA
14. TS13 DATA 30. TS29 DATA
15. TS14 DATA 31. TS30 DATA
16. TS15 DATA 32. TS31 DATA
ESC-prev.menu; !-main menu; &-exit; @-scroll
Figure 4-38. Map Timeslot Menu
Matching the Remote E1 Settings
If in your application a central ASMi-52 unit with the E1 interface operates opposite
a remote ASMi-52 unit, the E1 settings of the remote device are automatically
matched to those of the local modem (the Units Identical Setting value is
permanently set to YES). For applications with two ASMi-52 units, the Units
Identical Setting value of the local modem overrides the management commands
from the supervisory terminal.
For ASMi-52 units operating in G732S framing or in unframed mode, the Units
Identical Setting value is permanently set to YES.

To match the remote E1 settings:
1. From the E1 Port Configuration menu, select Units Identical Setting.
The Units Identical Setting value changes to YES.
2. Save the changes.
Note