User`s manual

Chapter 6 Configuring FCD-IP for a Typical Application RADview FCD-IP User’s Manual
6-2 Configuring WAN Parameters
Table 6-1. Configuration Summary
WAN Parameters E1 Parameters LAN Host Parameters
• Link mode: Synchronous
• Routing: IP router
• Protocol: PPP
• WAN IP address: 192.168.10.1
• WAN IP mask: 255.255.255.252
• Master clock: Link 1
• Multiplier: 64 kbps
• Timeslots 1–4: FIX SUB Voice
• Timeslots 5–8: DATA LINK1
• LAN Status: Enable
• Host IP address: 192.168.10.2
• Host IP mask: 255.255.255.000
• Default gateway setting by:
Interface
• Default gateway interface: LINK 1
6.2 Configuring WAN Parameters
Configuring WAN parameters includes the following:
• Configuring the WAN Interface
• Configuring the WAN IP Address.
Configuring the WAN Interface

To configure the WAN interface:
1. Select Link1.
2. Switch to Edit View: Click the Edit View button on the toolbar
.
3. Select Configuration > Interface Info…
The Interface Information dialog box appears. There are two tabs: Info and
Link Data.
4. Click the Link Data tab.
Figure 6-2. WAN Interface Information Link Data Tab