User`s manual

Chapter 2 System Management RADview FCD-IP User’s Manual
2-12 OSPF
OSPF Areas

To display the OSPF Area Table:
• Select Configuration > OSPF > Area Table....
The OSPF Area Table appears.
Figure 2-12. OSPF Area Table
Table 2-7 OSPF Area Table Parameters
Parameter Possible Values / Remarks
ID The IP address of the area.
1.0.0.0..255.255.255.255
Behavior Type
Transit, Stub, NSSA
[Change…] Change an OSFP Area behavior by selecting an ID and clicking <Change…>. The
Change Area Parameters dialog box appears. Change parameters and click <Set>.

To change parameters of an area:
1. In the OSPF Area Table, click <Change…>.
The Change Area Parameters dialog box appears.
2. Configure desired parameters (see Table 2-7).
3. Click <Set>.
OSPF Area Aggregation

To display the OSPF Area Aggregation Table:
• Select Configuration > OSPF > Area Aggregation....
The OSPF Area Aggregation Table appears.