User`s manual

RADview FCD-IP User’s Manual Chapter 2 System Management
OSPF 2-13
Figure 2-13. OSPF Area Aggregation Table
Table 2-8 OSPF Area Aggregation Parameters
Parameter Possible Values / Remarks
Area The ID of the area.
1.0.0.0..255.255.255.255
IP The IP address of the network.
1.0.0.0..255.255.255.255
Mask A unique 32 bit value allowing the recipient of IP packets to distinguish between
different host IDs.
0.0.0.0..255.255.255.255
Advertised Advertising matching is enabled/disabled.
[Add…] Click <Add…> to open the Add Area Aggregation dialog box
(Figure 2-8). Enter the desired parameters and click <Set>.
[Change…] Change an address from the Area Aggregation Table by selecting an address and
clicking <Change…>. The Change Area Aggregation dialog box appears. Change
parameters and click <Set>.
[Remove] Remove an address from the Area Aggregation Table by selecting an address and
clicking <Remove>.