User`s manual

RADview FCD-IP User’s Manual Chapter 2 System Management
Configuring the Dynamic Host Configuration Protocol (DHCP) 2-19
2.7 Configuring the Dynamic Host Configuration
Protocol (DHCP)
RADView enables you to configure the Dynamic Host Configuration Protocol
(DHCP).

To display the DHCP:
• Select Configuration > System Commands > DHCP…
The DHCP table appears (Figure 2-19).
Figure 2-19. Dynamic Host Configuration Protocol Table
Table 2-13. Dynamic Host Configuration Protocol Parameters
Parameter Possible Values / Remarks
IP Address Allocation
Enable, Disable
Low IP Address Specifies the lower boundary for the IP address range.
High IP Address Specifies the upper boundary for the IP address range.
IP Mask Specifies the IP Mask for the IP address range.
Default Gateway Specifies the default Gateway IP address for workstations that receive IP addresses
in the range defined by Low and High IP Address.
Primary DNS The IP address of the DNS server that can be used by the workstation.
Secondary DNS The IP Address of an additional DNS server used as an alternative to the Primary
DNS.