User`s manual

RADview FCD-IP User’s Manual Chapter 2 System Management
Resetting the Device 2-21
Figure 2-21. Change DHCP Entry
2. Configure desired parameters (see Table 2-13).
3. Click <Set>.
The Add DHCP Entry dialog box closes.
2.8 Resetting the Device
RADview enables you to reset the device.

To reset the device:
1. Select Configuration > System Commands > Reset…
or
click the shortcut key on the toolbar
.
The following message appears: “RESETTING BROUTER. Operation may
disrupt network data.”
Figure 2-22. Reset Brouter
2. Click <OK> to confirm reset.
The system is reset.