User`s manual

Chapter 3 Port Management RADview FCD-IP User’s Manual

3-6 Configuring Interface Information

Configuring E1/T1 over SHDSL Interface Information

This section describes how to view and configure E1/T1 over SHDSL interface

information.

For information on E1/T1 interfaces that are not over SHDSL, see Configuring E1/T1,

CHANNEL, ISDN, and Voice Interface Information.



To configure interface information:

1. Select a Link or Channel.

2. Select Configuration > Interface Info…

The Interface Information dialog box appears. There are two tabs: Info and

Link Data.

This dialog box is divided into two sections: the upper section displays

SHDSL parameters and the lower section displays E1/T1 parameters.

Link Data tab is disabled for Sub links.

Figure 3-3. Interface Information Info Tab for E1/T1 over SHDSL

Note