User`s manual

RADview FCD-IP User’s Manual Chapter 3 Port Management
Configuring Interface Information 3-7
Figure 3-4. Interface Information Link Data Tab for E1/T1 over SHDSL
3. Click on the required tab.
4. Configure the desired parameters.
5. Click <Set>.
Table 3-5. Info Tab Parameters for E1/T1 over SHDSL
Parameter Possible Values / Remarks
Interface The selected interface.
Description Description of the selected interface.
Oper Status The operational status of link.
Up, Down
MTU The maximum Transmit Unit for IP fragmentation.
Frames lager than MTUare fragmented into smaller units when sent through the
specified interface
t
Changing the protocol type from Frame Relay (RFC 1490) to any other protocol will
cause the device to reset.
The following message appears “This operation will cause HW reset of the Device.
Continue?”
Click <OK> to confirm reset.
Note