User`s manual

Chapter 3 Port Management RADview FCD-IP User’s Manual
3-10 Configuring Physical Parameters
Table 3-7. Interface Information – Ethernet LAN Parameters (Cont.)
Parameter Possible Values / Remarks
Active Address
Burn In MAC Changing this parameter will cause disconnection with the agent.
Locally Administered Changing this parameter will cause disconnection with the agent.
LAN State
Enable, Disable
Selecting Disable for this parameter will cause disconnection with the agent.
Routing/Bridging
Bridge, IP Router, IPX Router, IP and IPX Router, IP Brouter, IPX Brouter,
IP and IPX Brouter
Note: Only for two LANS.
3.3 Configuring Physical Parameters
This section describes how to view and configure physical layer parameters of
Async, ISDN, E1/T1, and SHDSL ports.
• For information on configuring interface information, see Configuring Interface
Information.
• When configuring TDM parameters a password is required.
Configuring Async Link (V.24) Physical Parameters
Async links can only be V.24.

To configure Async physical parameters:
1. Select the Async Link.
2. Select Configuration > Physical Parameters…
The Async Link Parameters dialog box appears.
3. Configure the desired parameters.
4. Click <Set>.
Notes
Note