User`s manual

RADview FCD-IP User’s Manual Chapter 3 Port Management
Configuring Physical Parameters 3-17
Configuring General E1/T1 Physical Parameters

To configure E1/T1 general physical parameters:
1. Select an E1/T1 Link or Channel.
2. Select Configuration > Physical Parameters > General….
The E1/T1 Link Parameters dialog box appears.
Figure 3-12. General Link Parameters (E1/T1 Ports)
Table 3-14. General Link Parameters (E1/T1 Ports)
Parameter Possible Values / Remarks
Interface The selected interface.
Admin Status Enable, Disable
Clock Source The clock source that synchronizes the network.
Internal - system source clock is generated from an internal clock oscillator.
Link1 -
– Sublink1/Link 2
Sublink 1
Sublink 2
Sublink 3.