User`s manual

Chapter 3 Port Management RADview FCD-IP User’s Manual
3-22 Configuring Physical Parameters
Exiting the TS Assignment Window

To exit the TS Assignment window:
• Double-click the control box in the upper left corner of the window
or
click on the X in the upper right-hand side of the window.
Reading the E1/T1 Configuration from the Agent
Read is only available for TDM ports in Edit View.
RADview enables you to upload the current Agent configuration to the Edit
Configuration mode. The Read command is only available when there is
communication with the agent.

To read the current configuration from the agent:
1. Select a Link or Channel.
2. Select Configuration > Physical Parameters > Read...
The following message appears:
Figure 3-15. Read Configuration
3. Click <OK> to confirm the operation.
Updating the E1/T1 Configuration in the Agent
Update is only available for TDM ports in Edit View.
RADview enables you to download the Edit Configuration to the agent.

To upload the Edit Configuration to the agent:
1. Select a Link or Channel.
2. Click the Edit View button on the toolbar
.
3. Select Configuration >Physical Parameters > Update…
The following message appears:
Note
Note