User`s manual

Chapter 3 Port Management RADview FCD-IP User’s Manual
3-28 Configuring Physical Parameters
Table 3-17. Voice Parameters (Cont.)
Parameter Possible Values / Remarks
Tx Ring Detection This object represents 2 Octets, 4 nibbles:
A bit
, A bit Inverted, B bit, B bit inverted, NA (FXS and E&M)
where:
0001=Tx A bit
0010=Tx A bit inverse
0011=Tx B bit
0100=Tx B bit inverse
0000=NA
Default ABCD Bits For all interfaces:
When A bit or A bit inverted:
For E1 Link:
0001
, 0010, 0011, 0100, 0101, 0110, 0111
For T1 Link:
0000
, 0101
Else,
For E1 Link:
0001
, 0010, 0011, 1000, 1001, 1010, 1011
For T1 Link:
0000
, 1010
Reversed Polarity Indicates the Signaling Profile of the port.
Enabled, Disabled
Seize Ack Indicates whether the device will acknowledge a seize signal (On/Off Hook).
When the value is Yes and device receives an on/off hook signal, it will transmit
back an on/off hook signal.
When the value is set to No and device receives an on/off hook signal, it will NOT
transmit back an on/off hook signal.
Yes, No, NA (FXS and E&M)
Out of Service
Forced Idle, Forced Busy, NA (FXS)
Remote E&M Wires Remote device’s wiring.
2 Wires, 4 Wires, NA (FXS and FXO)
E&M Type Indicates signaling type on the E&M analog side.
Type 1, Type 2, Type 3, Type 5 (SSDC5), NA (FXS and FXO)