User`s manual

Chapter 3 Port Management RADview FCD-IP User’s Manual
3-32 Configuring Protocol Parameters
Figure 3-22. Add DLCI

To remove an entry from the DLCI Table:
1. In the DLCI Table, select an entry.
2. Click < Remove>.
Configuring PPP Parameters

To configure PPP parameters:
1. Select a Link or Channel.
2. Select a port where the Protocol Type (see Protocol Type) has been defined as
PPP.
3. Select Configuration > Protocols > PPP…
The PPP Protocol Parameters dialog box appears.
Figure 3-23. PPP Protocol