User`s manual

RADview FCD-IP User’s Manual Chapter 3 Port Management
Configuring Protocol Parameters 3-33
Table 3-21. PPP Protocol Parameters
Parameter Possible Values / Remarks
Interface The selected interface.
For ISDN the parameters will appear on two tabs: Channel 1 and Channel 2.
Bad Controls The number of packets received on this link with an incorrect control field.
Bad FCSs The number of received packets that have been discarded due to having an
incorrect FCS.
Local MRU
1 - 2147483648
Remote MRU
1 - 2147483648
Local to Remote ACC Map
4 octets
Remote to Local ACC Map
4 octets
Local to Remote Compression
Protocol
Enabled, Disabled
Remote to Local Compression
Protocol
Enabled, Disabled
Local to Remote ACC
Compression Protocol
Enabled, Disabled
Remote to Local ACC
Compression Protocol
Enabled, Disabled
Tx FCS Size
0 - 128
Rx FCS Size
0 - 128
Header and Control
Compression
Used for troubleshooting only.
Change the setting only if there is a problem with PPP negotiation.
Yes, No
Protocol Field Compression Used for troubleshooting only.
Change the setting only if there is a problem with PPP negotiation.
Yes, No
IP Compression Activates Van Jacobson TCP Header Compression on a specified link.
Yes, No
Note: Since PPP is used for point to point transmissions, both the local and
remote devices must have Van Jacobson TCP Header Compression enabled
for compression to be performed.