User`s manual

RADview FCD-IP User’s Manual Chapter 3 Port Management
Configuring Network Parameters 3-35
Configuring the IP Routing Protocol
Configuring the IP routing protocol varies slightly, depending on the software
version you are running. The appropriate one of the following two options will
appear in the Network Parameters menu:
• IP Routing Protocol
• IP RIP Mode

To set IP Routing Protocol:
1. Select a link in which protocol type is not FR.
2. Select Configuration >Network Parameters > IP Routing Protocol…
The IP Routing Protocol dialog box appears.
Figure 3-25. IP Routing Protocol Dialog Box
Table 3-23. IP Routing Protocol Parameters
Parameter Possible Values / Remarks
Interface The selected interface.
For ISDN the parameters below will appear on two tabs: Channel 1 and Channel 2.
Routing Mode RIP 1: Send and receive routing information about IP nets only
RIP 2: Send and receive full routing information including subnets
RIP 1 & RIP 2: Send and receive both RIP 1 (routing information about IP nets only)
and RIP 2 (full routing information including subnets)
OSPF: Routing is determined by the OSPF protocol
No Routing Protocol