User`s manual

RADview FCD-IP User’s Manual Chapter 3 Port Management
Resetting the Link 3-37
Configuring DHCP Relay

To set DHCP Relay:
1. Select the desired link.
2. Select Configuration >Network Parameters > DHCP Relay…
The DHCP Relay Parameters dialog box appears.
Figure 3-27. DHCP Relay Parameters
Table 3-25. DHCP Relay Parameters
Parameter Possible Values / Remarks
Interface Link 1, Link 2, Link 3
Description String containing information about the interface.
Type
DS1, MODEM, Frame Relay, PPP, SHDSL
Enable Relay
Enabled, Disabled
Relay IP Address 0.0.0.0, 1.0.0.0…223.255.255.255
3.6 Resetting the Link

To reset the link:
1. Select a Link or Channel.
2. Select Configuration > Reset…
or
click the Reset icon on the toolbar
.
The following message appears: “RESETTING LINK. Operation may disrupt
network data.”
3. Click <OK> to confirm Reset.