Specifications

Installation and Operation Manual Appendix D Supervision Terminal Commands
FCD-E1LC Ver. 1.0 Commands D-9
Parameter Function Values
RX_INBAND
Enables the activation of a main link
remote digital loopback in response
to the reception of the inband
loopback code from the remote
system
ENABLE – Inband loopback command
accepted.
DISABLE – Inband loopback command
ignored.
Default: DISABLE
INBAND_LOOP_
PATTERN
Selects the type of loopback
activation and deactivation
sequences
RDL LOOP – Use of the FT1/FE1 RDL
sequence in accordance with T1.403.
USER CONFIG – Use of user-defined
patterns.
Default: RDL LOOP
BERT_MODE
Selects the main link timeslots in
which the BER test will be performed
CH1 – The BER test will be made in the
timeslots assigned to data channel 1.
CH2 – The BER test will be made in the
timeslots assigned to data channel 2.
S1 – The BER test will be made in the
timeslots assigned to the sublink.
USER – The BER test will be made in the
timeslots selected by the user.
Default: CH1
USER_PATTERN_LEN
Defines the length of the
user-defined activation or
deactivation sequence.
This field is displayed only when
INBAND_LOOP_PATTERN is USER
CONFIG
The allowed range is 1 to 8.
Default: 1
USER_ACTIVATE_PAT
Used to specify a loopback
activation pattern.
This field is displayed only when
INBAND_LOOP_PATTERN is USER
CONFIG
Select 1 or 0 for each changeable place in
the template.
Default: 0
USER_DEACTIVATE_
PAT
Used to specify a loopback
deactivation pattern.
This field is displayed only when
INBAND_LOOP_PATTERN is USER
CONFIG
Select 1 or 0 for each changeable place in
the template.
Default: 0
If the BERT_Mode parameter is USER, then after pressing <Enter> to end the
selection of the loopback deactivation pattern you will see the first row of the
timeslot selection map. A typical display is shown:
TS 01 TS 02 TS 03 TS 04 TS 05 TS 06 TS 07
NO NO NO NO NO NO NO