Specifications

Appendix D Supervision Terminal Commands Installation and Operation Manual
D-10 Commands FCD-E1LC Ver. 1.0
Use the following procedure to select the required timeslots:
• Move the cursor to the desired timeslot field by pressing the spacebar.
• To enable BER testing in this timeslot, type <F> or <B> to change the
selection to YES.
The default, NO, means that the timeslot can continue to carry payload while
a BER test is performed.
• After making the selections in the first line, press <Enter> to continue to the
second line (timeslots 8 to 14).
• Repeat the operations until the last line, ending in timeslot 31, is completed.
DEF CALL
Purpose
Define the call-out parameters for the FCD-E1LC dial-out function.
The specified call-out parameters are used by FCD-E1LC to build the call
command that is sent to the dial-out modem. The modem connected to the
CONTROL DCE connector must be set up as follows (for convenience, the Hayes
commands required to select the specified parameters are listed in brackets):
• Auto-answer mode (AT S0=1)
• Call set up in response to the CONNECT string (AT X0)
• No echo (AT E0)
• Verbose mode (no codes, e.g., CONNECT string instead of 0) (AT V1).
Syntax
DEF CALL
Use
1. To define the call-out parameters, type:
DEF CALL<Enter>
You will see the first page of the call-out parameters data form. A typical
display is shown below.
NUM_OF_RETRIES WAIT_FOR_CONNECT DIAL_MODE
ALT_NUM_NUMBER
0 30SEC TONE NO
2. Change the parameter values as follows:
 Bring the cursor to the beginning of the first field to be changed by
pressing the spacebar.
 To change the selected field, press <F> or <B> to scroll among the
available selections.