Specifications

Appendix D Supervision Terminal Commands Installation and Operation Manual
D-12 Commands FCD-E1LC Ver. 1.0
Table D-3. Call-Out Parameters
Parameter Function Values
NUM_OF_
RETRIES
This parameter is used to control the number of
dialing retries.
The NUM_OF_RETRIES parameter applies to both
the primary and the alternate numbers:
• If the call is not established after dialing the
primary directory number the specified
number of times, FCD-E1LC attempts to
establish the call by dialing the alternate
directory number (provided the use of an
alternate number is enabled by means of the
ALT_NUM_MODE parameter).
• If the call cannot be established within the
specified number of redialing attempts on
neither of the two directory numbers,
FCD-E1LC stops the call attempts. When a
new alarm report must be sent, the call
attempts are started again. The user is
notified that the call attempts failed by a
message recorded in the alarm buffer
(separate messages are provided for each
directory number).
0 No redialing attempts are made
if the call is not established on
the first attempt.
1 to 8 If the call is not established on
the first attempt, FCD-E1LC will
redial the specified number of
times.
Default: 0
WAIT_FOR_
CONNECT
This parameter specifies the time FCD-E1LC will
wait for an answer after each dialing attempt. If
the called station does not answer within the
specified time, FCD-E1LC disconnects. If
additional call attempts are allowed, FCD-E1LC
will redial immediately after disconnecting.
The available selections are 30, 45, or 60
seconds.
Default: 30
DIAL_MODE This parameter is used to select the dialing
mode.
Select the dialing mode supported by the
telephone network.
TONE The modem is instructed to use
DTMF dialing.
PULSE The modem is instructed to use
pulse dialing.
Default: TONE
ALT_NUM_
MODE
This parameter is used to control the use of an
alternate number. The alternate number is
dialed after the specified number of call
attempts on the primary number failed.
NO No alternate number. In this case,
the FCD-E1LC stops the call
attempts after the specified
number of call attempts on the
primary number failed.
YES The use of an alternate number is
enabled.
Default: NO