Specifications

Appendix D Supervision Terminal Commands Installation and Operation Manual
D-28 Commands FCD-E1LC Ver. 1.0
DEF ROUTE
Purpose
Define network management stations for which all the management traffic will be
statically routed via the FCD-E1LC supervisory port, CONTROL DCE.
You can define static routes for up to 5 stations. A route is defined by specifying
the IP address of the corresponding station.
You do not need to manually include stations with static routes in the managers
list (see the DEF MANAGER LIST command): traps will be sent to the defined
stations via the supervisory port even if the station does not appear in the
managers list.
Syntax
DEF ROUTE
Use
1. To define a route, type:
DEF ROUTE<Enter>
You will see the current list of routes, in the following format:
ROUTE IP ADDRESS 1 IS: = 192.168.238.001
ROUTE IP ADDRESS 2 IS: = 192.168.200.253
ROUTE IP ADDRESS 3 IS: = 192.168.238.203
ROUTE IP ADDRESS 4 IS: = 192.114.029.209
ROUTE IP ADDRESS 5 IS: = 255.255.255.000
After the current table, you will see the first row of the routes data form,
which is used to define the IP address of the first management station.
2. Type in the IP address of the desired management station. Use the
dotted-quad format (four groups of digits in the range of 0 through 255,
separated by periods).
After filling in the required address, press <Enter> to display the next row.
Repeat the procedure to define the additional route (2 through 5). After
pressing <Enter> for the fifth route, you will see the full updated list, and the
command ends.
DEF SL
Purpose
Define the sublink parameters, and select the timeslots transferred to the main
link.
This command is accepted only by FCD-E1LC units with sublink.