User guide

Quantity One User Guide

13-6

Still using Add/Adjust Anchors, click anywhere on the dashed lines of the

frame border. This creates additional anchor points, both where you clicked

and on the other side of the frame. This also creates another dashed line

across the frame

You can then drag the new anchor points just as you did the corner anchor

points, thereby “bending” the frame. Other internal anchor points can be

placed along the new dashed line if further adjustments to the lane frame are

required.

You can create as many additional anchors as necessary for the lines of the

frame to correspond to the lanes on the gel image. If you change your mind

about the position of an anchor, you can reposition it by simply dragging it.

Fig. 13-6. Adjusting the anchor points of the lane frame.

Removing/Unadjusting Anchor Points

If you decide to remove an anchor point, select Unadjust Anchors from the

Edit Frame submenu or toolbar and click on the anchor you want to remove.

The anchor will disappear and the lanes will “unadjust,” reﬂecting the

removal of the anchor.

New anchor points

New anchor lines