User guide

Lanes
13-7
13.1.c Defining a Single Lane
You can define individual lanes using the single lane functions. These are
located on the Single Lane submenu of the Lane menu or on the Lane Tools
toolbar.
Fig. 13-7. Single Lane tools.
Note: You can use the single lane commands on lanes within a frame; however,
the lane will be detached from the frame before the command is executed.
To mark an individual lane, select Create Lane, then drag a line from the top
to the bottom of the desired lane.
Repeat this procedure to manually mark all the lanes you want to identify on
your gel image.
Note: If while defining lanes your lane numbering gets out of sequence, click on
Edit > Sort and Recalculate to renumber the lanes.
13.1.d Adjusting Single Lanes
You can adjust the position of any individual lane line you create by using the
Adjust Lane command.
Select Adjust Lane, then either drag one of the existing anchor points or click
anywhere on the lane to create a new anchor point and drag it to the desired
position. Repeat this procedure as many times as necessary until the lane line
accurately follows the lane on the gel image.