User guide

Quantity One User Guide
15-20
Outlier excludes a known (green) band from the band set model. However,
the band will still be marked as known.
Show Band Types displays all the red, green, and yellow bands on the image,
with the band type numbers next to the matched bands.
Show Band Models displays the band set modeling lines across the gel image.
Standard Curve displays the Standards Regression Curve (see section 15.1.b).
Click on the button, then click on any lane in the image.
Other Band Set Form Functions
The band set units are displayed in the top half of the form, as is the matching
tolerance used. Tolerance is the minimum spacing between band types that
you specified when you created the band set.
The Normalization button allows you to pick a specific band type to
normalize the relative quantities of your other bands against (see section 12.2,
Differential Display, for more information).
Click on the resize button in the lower right corner to reconfigure the form to
its smaller, palette version, which displays only the tool buttons and band
type buttons.
To delete the band set, click on the Delete button.
To close the band set, click on OK.
Note that the band set is saved when you save the image.
15.2.c Tips for Gels Without Standards
Ideally, if you are not using standards in your gels, you will have more than
one lane containing a reference sample in your gel. After you’ve used this
reference sample to create a band set, you should apply that band set to other
reference sample lanes using the Propagate Band Set button (in the Band Set
form).