Specifications

Chapter 2 Installation and Setup FOM-40 Installation and Operation Manual
2-4 Installing FOM-40
Connecting the Power
To connect FOM-40 to the power source, refer to the appropriate section below,
depending on your version of the unit (AC or DC).
Before switching on this unit and connecting any other cable, the protective
earth terminals of this unit must be connected to the protective ground
conductor of the mains power cord. If you are using an extension cord (power
cable) make sure it is grounded as well.
Any interruption of the protective (grounding) conductor (inside or outside the
instrument) or disconnecting of the protective earth terminal can make this
unit dangerous. Intentional interruption is prohibited.
AC Power Connection
Supply AC power to FOM-40 through the 1.5m (5 ft) standard power cable
terminated by a standard 3-prong plug. The cable is provided with the unit.

To connect AC power:
1. Connect the power cable to the power connector on the FOM-40 rear panel.
2. Connect the power cable to the mains outlet.
The unit turns on automatically when connected to the mains.
DC Power Connection

To connect DC power:
Refer to DC power supply connection supplement.
Warning