Specifications

Appendix B IR-ETH/QV Interface Module FOM-40 Installation and Operation Manual
B-4 Installation and Operation
B.4 Installation and Operation
Figure B-3 shows the DIP switch locations and the default settings of the
IR-ETH/QV PCB.
The screen print tables on the IR-ETH/QV PCB are look-up tables of the enabled
function settings. The tables do not show the default settings. For example, MDI in
OFF position, MDI is enabled.
SW2
ON
5. 6. 4. 3. 2. AN
FDX NC NC NC
1. 100
SW1
5. 7. 6. 8. 4. 3. 2. NC
NC FLC FIL NC FP NC
1. MDI
ON
Figure B-3. SW1 and SW2 DIP Switch Locations
Setting the DIP Switches
Configure the IR-ETH/QV module by setting the DIP switches SW1 and SW2 in
accordance with Figure B-3, Table B-2 and Table B-3.
After making changes in the flow control and LAN filtering switches, reset FOM-40 to
make the changes take effect.
Note
Note