Specifications

FOM-40 Installation and Operation Manual Appendix B IR-ETH/QV Interface Module
Installation and Operation B-5
Table B-2. DIP SW1 Switch Settings
Section Name Description Possible Settings Factory Setting
1 MDI Automatic MDI/MDIX
crossover
ON – Automatic MDI/MDIX
crossover is disabled
OFF – Automatic MDI/MDIX
crossover is enabled
OFF
2, 3 NC – – –
FLC Flow control (full-duplex) /
Backpressure (half-duplex)
4
Note: Flow Control (full duplex) is active
only if autonegotiation is enabled
ON – Flow control/Backpressure is
enabled
OFF – Flow control/Backpressure is
disabled
ON
5 FIL
LAN filtering ON – LAN filtering is disabled
OFF – LAN filtering is enabled
OFF
6 FP
Fault propagation ON – Fault propagation is disabled
OFF – Fault propagation is enabled
ON
Note: When fault propagation is enabled, the LAN interface shuts down if a failure is detected on the E1 line.
When fault propagation is disabled, the link integrity is not influenced by the E1 behavior.
7, 8
NC – – –
Switches SW1/ 2, 3, 7, and 8 of the SW1 DIP switch are factory-set and must not be
moved by the user.
Table B-3. DIP Switch SW2 Settings
Section Name Description Possible Settings Factory Setting
1 100 LAN speed
ON – LAN speed is set to 10 Mbps
OFF – LAN speed is set to 100 Mbps
OFF
2 AN LAN autonegotiation
ON – LAN autonegotiation is disabled
OFF – LAN autonegotiation is enabled
OFF
3 FDX LAN duplex mode
ON – LAN half-duplex mode
OFF – LAN full-duplex mode
OFF
4, 5, 6 NC – – –
• Switches SW2/4, 5, and 6 of the SW2 DIP switch are factory-set and must not
be moved by the user.
• When autonegotiation is enabled, LAN speed and LAN duplex mode are
configured automatically (switches SW2/1 and 3 are disabled).
Note
Notes