Specifications

RICi-E3, RICi-T3 Ver. 1.0 Configuring for Management 4-1
Chapter 4
Configuration
This chapter illustrates the RICi-E3, RICi-T3 configuration screens and explains
their parameters.
For quick reference, a menu tree of the RICi-E3, RICi-T3 management software is
available in
Chapter 3 .
The remaining sections in this chapter explain the parameters available via the
respective options in the Main menu.
For convenience, parameters that are mandatory for configuration, such as IP
parameters of the RICi-E3, RICi-T3 host or forwarding mode, are provided in the
Quick Setup menu (Main menu > Configuration > Quick Setup). For information
on this menu, refer to the Quick Start Guide at the beginning of this manual. For
additional information on the associate parameters, refer to the relevant sections
in the configuration chapter.
Menus are illustrated for both RICi-E3 and RICi-T3. The menus are the same
unless specified otherwise
4.1 Configuring for Management
For first use, you have to configure management parameters via an ASCII terminal
connected to the CONTROL port. Once the host IP parameters are set, you may
access RICi-E3, RICi-T3 via ConfiguRAD or RADview to continue configuring for
operation. To configure RICi-E3, RICi-T3 for management, do the following:
• Configuring IP Host Parameters
• Entering Device Information
• Configuring Communities
• Configuring the Host Encapsulation
• Configuring the Network Managers
• Controlling the Management Access
Note