Specifications

Chapter 4 Configuration Installation and Operation Manual
4-12 Configuring for Operation RICi-E3, RICi-T3 Ver. 1.0
 To configure the Ethernet port:
1. From the Physical Ports menu, select Ethernet.
The Ethernet menu appears as illustrated in
Figure 4-9 .
RICi-E3, RICi-T3
Configuration > Physical Ports > Ethernet
1. Administrative Status (Up)
2. Auto-Negotiation (Enable)
3. Flow Control (Enable)
4. Max Capability Advertised (100base - TX Full Duplex)
5. MDIX Auto cross over (Enable)
>
ESC-prev menu; !-main menu; &-exit 1 user(s)
Figure 4-9. Ethernet Menu
2. In the Ethernet menu, configure the following:
 Administrative Status
 Up – the network port is enabled
 Down – the network port is disabled.
 Autonegotiation
 Enable – autonegotiation is enabled
 Disable – autonegotiation is disabled
 Flow Control
 Enable – flow control is enabled
 Disable – flow control is disabled.
 Max Capability Advertised. The highest traffic handling capability to be
advertised during the autonegotiation process
 10baseT Half Duplex
 10baseT Full Duplex
 100baseTX Half Duplex
 100baseTX Full Duplex.
 MDIX Auto cross over
 Enable – MDIX Auto cross over is enabled
 Disable – MDIX Auto cross over is disabled.
3. Select Save to complete the network Ethernet port configuration.