- RAD Data Communications LRS-24 12-slot Link Access Rack with SNMP Version 3.00 Installation and Operation Manual

LRS-24 Installation and Operation Manual Appendix D CM-2 Management Commands
Defining LRS-24 And CM-2 SNMP Agent Parameters D-7
Table D-3 DEF HUB Command Fields (Cont.)
Field Name Description Options
BURN IN MAC ADDRESS Fctory MAC address used by BOOTP server to
declare the IP address of the CM-2.
BOOTP ON/OFF Toggle to select BOOTP.
To maintain backwards compatibility (with any
LRS-12 version), set BOOTP ON/OFF to OFF.
Otherwise, BOOTP ON/OFF should be set ON.
In either case, BOOTP ON/OFF should be set to
OFF while setting the IP address.
ON– use BOOTP
OFF–no BOOTP.
Default value: OFF
BOOTP TIME OUT Maximum waiting time for a BOOTP response
1, 2, 3, 4, 6, 8, 10, 15, 20
seconds.
Default value: 10 seconds
BOOTP RETRIES Number of times to retry sending a request for the
BOOTP server
3, 4, 5, 10, 15, 20, 25, 30 times.
Default value: 30 times
HUB IP MODE SINGLE – only one IP address.
(The LRS-24 address is the CM-2
address.). CM-2 receives SMOD
message and transfers to it to the
SMOD modem after adjusting
the IP. The IP is resolved from
the community field. In this
mode, ping and Telnet cannot
be used directly on an SMOD;
only the CM-2 IP address is
relevant.
MULTIPLE – normal mode.
Every SMOD has its own IP
address and the CM-2 does not
interfere at the IP level. Every
SMOD IP is calculated by
adding the CM-2 IP address and
the SMOD slot number.
SERIAL LINE PROTOCOL SLIP Protocol RS232 – terminal
STATION CLOCK Set clock for station Internal
External – Square
Ext-AMI
Order from: Cutter Networks
Ph:727-398-5252/Fax:[phone]
www.bestdatasource.com