- RAD Data Ethernet Remote Access Router Installation And Operation Manual

MBE Family Installation and Operation Manual Chapter 2 Installation

Installation and Setup 2-9

Connecting the Power

AC Power

Supply AC power to the MBE unit through the 1.5m (5 ft) standard power cable

terminated by a standard 3-prong plug. The cable is provided with the unit.

A 2A slow-blow fuse is located in the power supply unit.

To prevent electrical fire hazard, always replace the fuse with the same type

and rating as indicated.

➤ To connect AC power to the MBE unit:

1. Connect the power cable to the power connector on the MBE rear panel.

2. Connect the power cable to the mains outlet.

3. Set the POWER switch to ON.

Warning

Order from: Cutter Networks

Ph:727-398-5252/Fax:727-397-9610