System information

Chapter 2 Agent Configuration Mode RADview-PC/TDM Megaplex-2100/2104 User’s Manual
Figure 2-12. Flip DB Decision Table
Table 2-7. Flip DB Decision Table Parameters
Parameter Possible Values / Remarks
Flip Index Index number of the entry in the Table according to the order of priority.
When multiple event combinations cause flipping to more than one configuration at the
same time, RADview will activate the entry that comes first in the Decision Table.
Logical Expression Combination of net events, which, if they occur, causes RADview to flip to a specific
Megaplex configuration.
The expression consists of event numbers and the following logical symbols (maximum of
19 characters):
& - AND
| - OR
! – NOT
( ) – Parentheses enclose a combination of events that comprises a single condition in the
logical expression.
For example, (2&51)|(!102&4) means that (event no. 2 exists AND event no. 51 exists)
OR (event no. 102 does not exist AND event no. 4 exists).
Note: The logical expression cannot begin with a blank space.
Flip to Config No. ID number of the Megaplex configuration that will be activated if the events written in
the logical expression occur
Enable
√ in the Enable column indicates that an entry is valid
Net Update
The Net Update command opens up a submenu that includes commands for
setting an activating delay time, and for activating a Flip configuration in all
Megaplexes in the net.
Figure 2-13. Net Update Submenu
Setting the Net Update Delay
The Delay command allows you to set the time required for all the Megaplexes in
the net to activate the Flip configuration.
2-14 System Level Agent Operations