System information

Chapter 2 Agent Configuration Mode RADview-PC/TDM Megaplex-2100/2104 User’s Manual
Displaying Redundancy Table Parameters
The Redundancy Table command enables you to display the redundancy
parameters for the Megaplex.
Note
The redundancy table is not displayed in agent mode for agent version 5.28.

To view redundancy table parameters:
• From the Configuration menu, select Redundancy Table….
The Redundancy Table dialog box appears. Fields in the table (marked
with an asterisk *) can be reordered by clicking on their columns.
Redundancy Mode will display the parameters in the following order: Y
Cable, and Dual Cable Parallel Tx. Additionally every group will be
displayed according to Primary Slot and Port ascending order.
Figure 2-20. Redundancy Table Dialog Box
Table 2-10. Redundancy Table Parameters
Parameter Possible Values / Remarks
Redundancy Mode Redundancy Mode for the card
Y Cable, Cable Parallel Tx
Primary Slot Primary Slot for the card
NA, IO-1..IO-12
Primary Port Primary Port for the card
external-1..external-2, internal-1, Bundle1..Bundle120
Secondary Slot Secondary Slot for the card
NA, IO-1..IO-12
Secondary Port Secondary Port for the card
external-1..external-2, internal-1, Bundle1..Bundle120
Recovery Time (sec) Recovery time in seconds
1..99
2-20 System Level Agent Operations