System information

Connecting RADview Management Station to TDM 1-1
Chapter 1
Edit Configuration Mode
This section describes the Megaplex management operations that can be
performed in RADview’s Edit Configuration mode.
1.1 Connecting RADview Management Station to TDM
The RADview management station may be connected to Megaplex units in one of
the following setups:
• Direct management-to-TDM link running on Single Line Internet Protocol
(SLIP)
• Connection from management station in a LAN through an MBE to a TDM
unit.
Direct Management Connection
In this application, the management station is connected directly to a Megaplex
unit. If more than one device is installed on this network, the device directly
connected to management is the local unit. Any other devices are remote.
This application requires installation of SLIP. It is the customer's responsibility to
acquire a SLIP communication program and to install it according to the
manufacturer's instructions. RADview supports both public domain SLIP and
vendor SLIP.
Figure 1-1 shows a sample direct management application.
RADview-PC
Management Station
SLIP
Megaplex
Figure 1-1. Direct Management Application