System information

Chapter 2 Agent Configuration Mode RADview-PC/TDM Megaplex-2100/2104 User’s Manual
Parameter Possible Values/Remarks
Jitter Buffer (tens of
µsec)
Depth of the jitter buffer (elastic buffer per link whose size is configurable in units
of 10 micro seconds (µs).
300..30,000 tens of µs
ToS IP ToS (Type of Service) assigned to this channel
0
-255
Configures IP ToS field in the IP frames transmitted by the device. Configures the
entire byte – not only the 3 ToS bits. ToS assignment applies to all TDM packets
leaving mux.
TDM Bytes in Frame UDP payload (one-eight) length enabling reduction of Ethernet throughput.
48
, 96, 144, 192, 240, 288, 336, 384
VLAN Tagging
No
, Yes
VLAN ID VLAN ID: 0-4000
VLAN Priority VLAN Priority (Enabled only when VLAN Tagging=Yes)
0
-7
Exit Port
External–1
, External–2, Auto
Voice OOS Voice out-of-service code transmitted on voice time slots when the link is
out-of-service. This value must be the same for both ports. To change the code,
type the required code in the edit box
00-FF (hexadecimal)
Data OOS Data out-of-service code transmitted on data time slots when the link is
out-of-service. This value must be the same for both ports. To change the code,
type the required code in the edit box
00-FF (hexadecimal)
Displaying Managers Routing Table

To view the Managers Routing table:
• From the Configuration menu, select MNG Routing Table…
The Managers Routing Table appears.
Figure 2-24. Managers Routing Table
2-24 System Level Agent Operations